Inkjet Instructions

Step #1: Design your decals using any graphic software program. (Use Print Decal's 8.5" x 11" sheet decal paper or cut sheet into half if desired.)

Step #2: Set your printer as follows:
- Resolution = Best
- Paper = Photo Gloss
(Print your decal on the glossy side of Print Decal's decal paper.)

Step #3: Spray your printed sheet evenly with Krylon Acrylic Crystal Clear High Gloss spray until the sheet has a shine (2-3 coats). Allow 30 to 60 minutes to dry and set. (This product is available at any craft or hardware store such as Loews, Home Depot, Ace Hardware, Walmart, etc. Any acrylic clear coat spray will work.)

Step #4: Cut out your image using a standard pair of sharp household scissors.

Step #5: Place decal into a cup of clean water for
45-60 seconds and remove when the thin decal film begins to slip along backing. (Discard backing material after the decal has been removed)

Step #6: Apply decal to clean surface; ceramic, glass, metal, plastic, soap, candles, mylar balloons, model trains, planes, cars, etc.
Use a clean damp cloth or paper towel to wipe off excess water and remove any air bubbles that may appear. Allow setting time of about 3 hours. Your decorated object is ready!

Note: You can speed up drying time by placing your decorated object under/near a fan.

If you wish to protect your decorated item from surface scratches, moisture, or fading, then spray your dried decorated surface with an acrylic varnish such as Krylon Crystal Clear finishing spray.