 |
|||||||||||||||
|
Laser
Instructions Step #1: Begin by removing the paper's film before placing it into the printer. Print on the glossy side of the blank paper. Step #2: Print your image(s) from your computer onto your laser printer, color copier or ALPS printer with the use of Print Decal blank laser paper. Note: You should feed your printer one sheet at a time to avoid jamming the printer since this paper is thicker than regular paper. If you take it to a copy center, instruct the operator to feed the copier one by one the sheets to the copy machine. Step #3: Allow the ink to dry and set into the paper for at least five minutes and it should be ready for application. Step #4: Cut out the image(s) as close as possible to the actual design and place them in lukewarm water for approximately 30 seconds. Hold the decal carefully to avoid tearing. You will begin to feel the printed image start to slide off the white backing paper. This means it is ready to apply onto your surface to decorate. Step #5: Apply decal to clean surface, gently slide the decal into place. Use a clean damp cloth or paper towel to wipe off excess water and remove any air bubbles that may appear. Allow setting time of about 3 hours. Your decorated object is ready! Note: You can speed up drying time by placing your decorated object under/near a fan. If you wish to protect your decorated item from surface scratches, moisture, or fading, then spray your dried decorated surface with an acrylic varnish such as Krylon Crystal Clear finishing spray. |
||||||||||||||
